![]() ![]() The board is kept cool by a metal heat spreader plate occupying most of the bottom cover area. The board shot taken from the FCC ID docs shows two bent-metal dual-band dipole antennas affixed to the board. This device combines a 717 MHz quad-core ARM Cortex A7 processor and 2×2 2.4 and 5 GHz radios, making for a clean design. This isn’t a big deal, since MU-MIMO is of questionable benefit. But despite being described as a "Wave 2" device, the DAP-2610 does not support MU-MIMO. It’s based on Qualcomm’s IPQ4018 2×2 Wi-Fi SoC, which means it’s capable of supporting MU-MIMO and, in fact, is the only AP in this roundup to support it. Typical Price: $136 Buy From Amazon Updated 12/4/17ĭ-Link’s DAP-2610 has a design more like the recent crop of consumer "mesh" Wi-Fi systems than most of the other APs in this group. Poor 5 GHz performance in open air testing.Lots of client bandwidth management options. ![]() Many management options including built-in AP cluster controller.Qualcomm-based 2×2 AC1300 class “Wave 2” access point with PoE and support Jim Salter will be following up with a review of each product’s performance in a three-AP home setup.ĭ-Link Wireless AC1300 Wave 2 Dual-Band PoE Access Point (DAP-2610) I’m covering the basic product descriptions, component breakdowns and chamber-based throughput vs. So you’ll need 802.3at switches to power them. Devices designated 802.3at draw more power than those spec’d 802.3af. It’s important to pay attention to the difference if you’re planning on using PoE. We wanted to include EnGenius’ EAP1300 in this roundup, but the company would not provide sufficient review samples.Īll products have at least one gigabit Ethernet port and can be powered by 802.3af or 802.3at Power over Ethernet. We wanted to include NETGEAR’s WAC505 and EnGenius’ EAP1300 in this roundup, but neither company provided sufficient review samples. So we rounded up the seven eight products listed below for test, ranging in cost from a low of around $60 to a high of around $160, with plenty of others hovering around the $100 mark. They are relatively low cost and match the dual-stream capabilities of most devices you’re likely to connect to your WLAN. When using multiple APs, 2×2 AC1200 devices are the sweet spot. ![]() If you’re fortunate enough to have a large/multi-level home with Ethernet where you need to locate access points, there really is no reason to mess with more expensive mesh Wi-Fi systems, Wi-Fi extenders or even big, expensive conventional routers. It seems like more people are realizing the performance (and cost) advantages that building a Wi-Fi network with Ethernet-connected access points (APs) can provide. Note: Additional testing on these products can be found here. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |